EASYCLICK – RAPID CONNECTOR SYSTEM
EASYCLICK - Rapid connector system
The connection is ready in less than 2 minutes.
Quick assembly: Simply cut - join - twist the heating strip - and it's ready. The connection is ready in as little as 2 minutes, and a final connection in as little as 30 seconds.
The ETHERMA EASYCLICK rapid connector for ETR heating strips makes handling even safer and easier, even faster and hence more cost-effective to assemble. Only a ruler and a wire cutter are needed in order to set up a heating circuit. No burdensome exposing of the two braids, no splicing and twisting of the protective braid, no connection to a terminal.
Simply remove a piece of the outer mantle, insert a clamp over the exposed and visible braid, and place the remaining overhanging part of the braid over the clamp. Finally, guide the heating strip into the clamping sleeve and a contact is established between the heating strips using clamping and cutting technology by twisting the two outer sleeves together (one sleeve comes ready-fitted with a 1.5 m long connector cable). The final connection consists of only a single component - into which the end of the heating strip is trimmed to size, and inserted into the end-piece.
Reduced installation costs thanks to simple, fast handling
Excellent installation safety with no shrinkage
Secure contacts thanks to precise clamping and cutting technology
Flexibility on the construction site - You are prepared for all eventualities
|Rated current:||16 A|
|Ambient temperature:||- 25°C to + 60°C|
|On request:||- 25°C to + 85°C|
|IP rating:||IP 66|